33 32 REAR CONTROL ARMS, TRAILING ARMS (M3 base, M3 Competition, M3 Competition M xDrive, M3 CS)
3332 TIGHTENING TORQUE OVERVIEW
| Camber control arm to rear axle support | ||
| M14 Replace screw and nut Tighten in NORMAL POSITION . Tightening via screw |
Tightening torque | 100 Nm |
| Angle of rotation | 90° | |
| Camber control arm to wheel carrier | ||
| M14 Replace eccentric screw, eccentric washer and nut |
Tightening torque | 165 Nm |
| Front lower wishbone to rear axle support | ||
| M12 Replace screw |
Tightening torque | 100 Nm |
| Front lower wishbone to wheel carrier | ||
| M12 Replace screw Tighten in NORMAL POSITION . |
Tightening torque | 100 Nm |
| Lower rear wishbone to rear axle support | ||
| M12 Replace screw |
Tightening torque | 100 Nm |
| Lower rear wishbone to wheel carrier | ||
| M12 Replace eccentric screw, eccentric washer and nut |
Tightening torque | 100 Nm |
| Upper wishbone at front/rear to rear axle support | ||
| M12 Replace screw and nut Tighten in NORMAL POSITION . Tightening via screw |
Tightening torque | 100 Nm |
| Upper wishbone at front/rear to wheel carrier | ||
| M14 Replace nut |
Tightening torque | 165 Nm |