Installing rear brake pads
- Install the brake pad (1) in arrow direction
- If necessary for brake pads with adhesive film, detach the protective film
- Equipment version of the design clip:
- Replace the design clip (1)
Parts: Design clip
The design clip (1) must be replaced after every disassembly
- Attach the design clip (1) and engage it in arrow direction with a screwdriver (2)
- Ensure that the retaining tab (3) is engaged correctly
- Remove the special tool (cable tie) 2 413 317.
- Mount brake caliper (3)
- Replace screws (1)
Parts: Screws
- Tighten the screws (1), if applicable, hold against the hexagon head (2)
TIGHTENING TORQUE SPECIFICATION
| Guide bolt (brake caliper on brake anchor plate) | ||
| M8 | tightening torque | 35 Nm |