Installing the steering column switch cluster (SZL)
- For replacement:
Break off the transportation retainer (1) on the steering column switch cluster (SZL) (2) in arrow direction
The broken off piece (3) of the transportation retainer (1) remains in the steering column switch cluster (SZL) (2)
- Connect the connector (1) with the steering column switch cluster (SZL) (2)
Check
- Version A;
Check if the correct mark (1) is visible in the inspection glass (2)
Result
No or an incorrect mark (1) is visible in the inspection glass (2)
Measure
- Turn the coil spring cassette until the correct mark (1) is visible in the inspection glass (2)
Check
- Version A:
Check that the correct marking (1) is visible in the inspection glass (2)
Result
The correct mark (1) is visible in the inspection glass (2)
Measure
- Continue with the next step
Check
- Version B:
Check if the correct mark (1) is visible in the inspection glass (2)
Result
No or an incorrect mark (1) is visible in the inspection glass (2)
Measure
- Turn the coil spring cassette until the correct mark (1) is visible in the inspection glass (2)
Check
- Version B:
Check if the correct mark (1) can be seen in the viewing window (2)
Result
The correct mark (1) is visible in the inspection glass (2)
Measure
- Continue with the next step
- Position the steering column switch cluster (SZL) (2)
- Tighten down screws (1) TIGHTENING TORQUES SPECIFICATION
Steering column switch cluster (SZL) to steering column Screw TS5x20 Tightening torque 3 Nm
Follow-up work
- Refer to INSTALLING STEERING COLUMN SHROUD LOWER SECTION .
- Refer to FITTING STEERING COLUMN SHROUD UPPER SECTION .
- Refer to GREASING THE SZL .
- Refer to INSTALLING THE STEERING WHEEL/M SPORT STEERING WHEEL .
- Refer to INSTALLING THE AIRBAG UNIT (M SPORT STEERING WHEEL) .
- Refer to RECONNECTING ALL BATTERY GROUND LEADS .