(Installing left and right hood lock)

Installing the right hood lock

Attach the cable (3)
Feed in the hood lock
Replace screws (2)
Parts: Screws

Tighten down screws (2)

(TIGHTENING TORQUE SPECIFICATIONS)

Hood lock
screw Replace screws	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connectors (1) and lock

Attach the cable (3)
Feed in the hood lock
Replace screws (2)
Parts: Screws

Tighten down screws (2)

(TIGHTENING TORQUE SPECIFICATIONS)

Hood lock
screw Replace screws	Tightening torque	8 Nm

Connect connectors (1) and lock

Courtesy of BMW OF NORTH AMERICA, INC.

Only on vehicles with active pedestrian protection

Disconnecting all battery ground leads

See ADDITIONAL INFORMATION .

Courtesy of BMW OF NORTH AMERICA, INC.

Activating the 48 V electrical system

Precondition

Ignition is switched off

NOTE: RISK OF DAMAGE
Damage to the 48-V battery
If a 48-V battery that is disconnected from the electrical system is activated, the battery electronics will be damaged

Only ever activate the 48 V electrical system when the 48 V battery is fully connected up

Raise the battery ground cable (1)
Remove special tool 2 452 007

Courtesy of BMW OF NORTH AMERICA, INC.
Release the negative battery cable (2) of the 48-V battery from the attachment
Position the negative battery cable (2) of the 48-V battery on the negative battery terminal

Tighten the nut (1)

(TIGHTENING TORQUE SPECIFICATIONS)

Negative battery cable to 48-V battery
Nut M8	tightening torque	19 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect the connector (1) of the CAN bus and lock it
Clip in the clip (2)

Courtesy of BMW OF NORTH AMERICA, INC.
Activate the 48 V electrical system by closing the hood

The activation takes place automatically

Courtesy of BMW OF NORTH AMERICA, INC.