Remove windshield panel cover

NOTE: TECHNICAL INFORMATION
Before installing the cowl cover, it is imperative to check the correct routing and firm fit of the 48V line
An incorrectly laid or attached 48V line can be damaged by the wiper kinematics

Preliminary work

Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
Refer to REMOVING THE COVER OF THE REAR RIGHT ENGINE COMPARTMENT .
Refer to REMOVING LEFT AND RIGHT WIPER ARM .

Release snap fastener (1) of the washer fluid hose (2) and put the washer fluid hose (2) to one side
Unclip the clips (3) on the windshield panel cover (4)

Courtesy of BMW OF NORTH AMERICA, INC.
Beginning from the side, pull up windshield panel cover (1) out of the detent (2)

Courtesy of BMW OF NORTH AMERICA, INC.