Remove front bumper cover
NOTE:
RISK OF DAMAGE
Mechanical effects
Paint damage
Mechanical effects
Paint damage
- Mask those working areas at risk with yellow plastic adhesive tape
- Remove and install heavy or bulky components with the aid of another person/other persons
NOTE:
In order to guarantee the quality of the Driver Assistance functions in vehicles with concealed radar sensors, please read and comply with the following notes:
Preliminary work
- Refer to REMOVING SEAL FOR FRONT HOOD .
- Refer to REMOVING THE COVER FOR THE CENTER ENGINE COMPARTMENT .
- Refer to PARTIALLY RELEASING THE FRONT LEFT AND RIGHT WHEEL ARCH TRIM PANELS .
- Refer to PARTIALLY REMOVING TEMPERATURE SENSOR .
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details
- Loosen screws (1)NOTE: Perform the steps on the left and right side
- Loosen screws (1)
- Release the bumper cover with the detents (2) and feed out of the guideNOTE: Perform the steps on the left and right side
- Unlock plug connection (1) and disconnect
- Unclip the connector (2) from the holder (3)
- If necessary, unlock and disconnect the plug connection (4)
- Loosen screws (1)
- Remove the bumper cover forward