Install A-pillar trim panel, left and right
NOTE:
Description is for left component only. Procedure on the right side is identical
Install A-pillar trim panel
WARNING:
Pyrotechnic components
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only
- Replace any damaged part or ones that have been dropped
- For additional information see: 72 00 SAFETY REGULATIONS on handling components with gas generators
NOTE:
RISK OF DAMAGE
Damage to the head airbag
Improper use of a tool when removing the trim panel may damage the head airbag
Damage to the head airbag
Improper use of a tool when removing the trim panel may damage the head airbag
- Do not use sharp-edged tools when removing the trim panel
Check
- Check the snap-in lug (1) of the cover (2) for damage
Result
» Snap-in lug is damaged
Measure
- Replace cover
Check
- Check the clips (1) for damage and replace if necessary
- Check guides (3) for damage
Result
» The guide is damaged
Measure
- Replace the A-pillar trim panel
- Insert the A-pillar trim panel (3) downwards and clip in with the clips (4)
- Tighten down screw (2)TIGHTENING TORQUES SPECIFICATION
A-pillar trim panel to body Sheet metal screw 4.8x38 Tightening torque 2.6 Nm - Clip in the cover (1)