Install rear spoiler

Determine the correct position of the rear spoiler 

• Glue on the adhesive tape (1) according to the dimension (A) in the center on the tailgate

  Dimension (A) = 350 mm

  Adhesive tape (1) must not be found on the bonding surface of the rear spoiler

  CONSUMABLE SPECIFICATION
  
  

  Yellow plastic adhesive tape

  83199410979

  Courtesy of BMW OF NORTH AMERICA, INC.

• Indicate the center of the tailgate on the adhesive tape (1)
• Check the rear spoiler

  Do not install rear spoilers with poor fitting accuracy

  A rear spoiler loosely placed on the tailgate must not protrude, especially at the corners

• Transfer the mid-centering (1) via adhesive tape to the outer side of the rear spoiler
• Place the rear spoiler (3) on the trunk lid and align to the adhesive tape

  Check whether the rear spoiler (3) is centrally seated on the tailgate

• Clean the bonding surface of the tailgate

  Courtesy of BMW OF NORTH AMERICA, INC.

  CONSUMABLE SPECIFICATION
  
  

  Cleaning agent R2

  500 ml

  83190417324

• Detach protective film (2) on the bonding surface, align rear spoiler (3) and stick it on the tailgate

  Press down with force on the rear spoiler (3) using the hands over the entire area, in particular at the edges

  NOTE: The adhesion of the adhesive tape builds up significantly via the contact pressure. Therefore, press thumbs or fingers over the entire area
• Remove the adhesive tape