Remove engine compartment lid catch

Preliminary work

Refer to REMOVING SEAL FOR FRONT HOOD .
Refer to REMOVING THE COVER FOR THE CENTER ENGINE COMPARTMENT .
Refer to REMOVING THE COVER IN THE ENGINE COMPARTMENT ON TOP .

Only on vehicles with active pedestrian protection

WARNING: Pyrotechnic components
Danger! Immobilization period-threatening injuries!

All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only
Replace any damaged part or ones that have been dropped
For additional information see: 72 00 SAFETY REGULATIONS on handling components with gas generators

Deactivating the 48 V electrical system

Precondition

Ignition is switched off

WARNING: Deactivate the 12-V electrical system
Risk of short circuits! Risk of fire!

Make sure that there is no battery charger connected to the jump start terminal in the engine compartment
For vehicles with additional electrical systems (48 V electrical system, high-voltage vehicle electrical system), this absolutely must be deactivated before the vehicle battery is disconnected

WARNING: Deactivate the 48-V electrical system
Risk of short circuits! Risk of fire!

Make sure that there is no charger connected to the jump start terminal in the engine compartment

NOTE: RISK OF DAMAGE
Damage to the 48-V battery
If a 48-V battery that is disconnected from the electrical system is activated, the battery electronics will be damaged

Only ever activate the 48 V electrical system when the 48 V battery is fully connected up

Deactivate the 48 V electrical system by opening the hood
Deactivation is automatic

Courtesy of BMW OF NORTH AMERICA, INC.

Check

NOTE: TECHNICAL INFORMATION
Zero voltage (48 V electrical system switched-off) is only displayed in PAD mode
Press the START-STOP button quickly 3 times without stepping on the brake pedal to establish the PAD mode
Check the de-energized state in the instrument cluster (KOMBI) in the PAD mode

Courtesy of BMW OF NORTH AMERICA, INC.

Desired state
- The Check Control message "48 V electrical system." switched off (1) is displayed
Result

» Absence of voltage cannot be specified with the Check Control message "48 V electrical system switched off." (1). Work start is not permitted

Measure
- Repeat the "deactivate 48 V electrical system" service function
  - Vehicle management > service function > voltage supply > deactivate 48 V electrical system
Only if the Check Control message "48 V electrical system switched off." (1) is displayed in the instrument cluster (KOMBI), the 12V battery may be disconnected

Contact the technical support if the absence of voltage is not clearly given

Result

» The Check Control message reports that 48 V electrical system is switched off

Measure
- Exit PAD mode by pressing the START-STOP button once without stepping on the brake pedal
"Disconnect the negative battery cable of the 48-V battery" work can be started
Unlock and disconnect the CAN bus plug connection (1) of the gear sensor
Release the clip (2)

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen nut (1)
Detach the negative battery cable (2) of the 48-V battery from the negative battery terminal, set to one side and secure

Courtesy of BMW OF NORTH AMERICA, INC.
WARNING:
Unprotected battery terminals
Risk of short circuits! Risk of fire!
- Cover the vehicle battery
Cover the vehicle battery with the special tool 2 452 007 as shown
Position the battery ground lead (1) as shown

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnecting all battery ground leads
See ADDITIONAL INFORMATION .

Courtesy of BMW OF NORTH AMERICA, INC.
Unlock plug connection (1) and disconnect
Loosen screws (2)
Feed out the hood lock in an upwards direction
Detach the cable (3) and remove the hood lock

Courtesy of BMW OF NORTH AMERICA, INC.