Installing the airbag control unit
WARNING:
Airbag unit
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Before performing any work on the airbag, always disconnect the battery ground lead from the battery
- Airbag unit may only be set down with the cushion (airbag itself) facing upwards
- For additional information see: 72 00... SAFETY REGULATIONS on handling airbag system components/gas generators
NOTE:
RISK OF DAMAGE
Electrostatic discharge
Damage to or destruction of electrical components
Electrostatic discharge
Damage to or destruction of electrical components
- Leave the electrical components in their original packaging until they are being installed. Only use the original packaging for returning the product. Always package removed components straight away
- Read and comply with user information on using the associated special tool 12 7 060
- Only tap the housings of electrical components. Do not tap pins or multi-pin connectors directly
- Wear electrically conductive clothing and antistatic shoes (with ESD symbol)
- For additional information see: 61 35... NOTES on ESD (electrostatic discharge) protection
- Position airbag control unit (3) correctly
- Tighten nuts (2) TIGHTENING TORQUE SPECIFICATION
Airbag control unit to body screw Tightening torque 8 Nm - Connect connectors (1) and lock
- Correctly position the insulation (1) and fasten the airbag control unit (2)
Follow-up work
- Refer to INSTALLING THE CENTER CONSOLE .
- Refer to INSTALLING THE REAR CENTER CONSOLE TRIM .
- Refer to INSTALLING THE STORAGE COMPARTMENT IN THE FRONT CENTER CONSOLE .
- Refer to INSTALLING THE OPERATING FACILITY IN THE CENTER CONSOLE .
- Refer to INSTALLING THE WIRELESS CHARGING STORAGE .
- Refer to INSTALLING THE DECORATIVE TRIM ON THE LEFT AND RIGHT OF THE CENTER CONSOLE .
- Refer to INSTALLING THE CENTER CONSOLE TRIM .
- Refer to INSTALLING TRIM IN STORAGE COMPARTMENT OF CENTER ARMREST .
- Refer to INSTALLING THE CUP HOLDER .
- Refer to RECONNECTING ALL BATTERY GROUND LEADS .
- Refer to ADJUSTING THE SENSORS FOR THE DRIVING DYNAMICS .