(Initializing the glass slide/tilt sunroof)
NOTE:
TECHNICAL INFORMATION
The following prerequisites are the basis for a correct initialization and must be strictly observed:
The following prerequisites are the basis for a correct initialization and must be strictly observed:
- Press and hold the switch in the "Vent Position" direction
The glass slide/tilt sunroof shifts to vent position
- In the event of a delayed start or sudden stop of the glass slide/tilt sunroof, continue to press and hold the switch in the "Vent Position" direction
- Continue to keep the switch pressed during the entire test module
- After reaching vent position (A), continue to press and hold the switch for about 30 s
The initialization starts:
- The glass slide/tilt sunroof shifts from vent position (A) toward position (B)
- Screen (sliding headliner) fully closes
- Screen (sliding headliner) fully opens
- Glass slide/tilt sunroof shifts to "closed" position
- The glass slide/tilt sunroof shifts to the "Open" position and immediately returns to the "Closed" position
- After a brief pause, the screen fully closes
The initialization is completed once the glass slide/tilt sunroof and the screen have completely closed
- Release the switchNOTE: TECHNICAL INFORMATION
If the switch is released in the meantime, repeat the initialization. Following successful initialization, the corresponding messages in the Check Control and the control display extinguish - Carry out functional check (one-touch mode, anti-trapping protection and, if necessary, comfort function)