Removing the Roof function center (FZD)

NOTE: RISK OF DAMAGE
Careless handling of tools and sharp-edged components
Scratches, surface damage

Protect working area
Handle tools and components carefully

NOTE: RISK OF DAMAGE
Electrostatic discharge
Damage to or destruction of electrical components

Leave the electrical components in their original packaging until they are being installed. Only use the original packaging for returning the product. Always package removed components straight away
Read and comply with user information on using the associated special tool 12 7 060
Only tap the housings of electrical components. Do not tap pins or multi-pin connectors directly
Wear electrically conductive clothing and antistatic shoes (with ESD symbol)
For additional information see: 61 35... NOTES on ESD (electrostatic discharge) protection

NOTE: TECHNICAL INFORMATION
With the optional equipment SA6UA, the camera for gesture control is integrated in the roof control module. Separate exchange of this camera in the event of a fault is not possible

Unclip the cover (1)

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen screws (1)

Courtesy of BMW OF NORTH AMERICA, INC.
Unclip the roof function center (FZD) (1) from the clamps (2)
Ease out the Roof function center (FZD) (1) from the guides (3)

Courtesy of BMW OF NORTH AMERICA, INC.
Unlock and disconnect plug connections (1)
Unclip the cable bracket from FZD (2) and remove FZD (2)

Courtesy of BMW OF NORTH AMERICA, INC.