Removing airbag unit (M Sport steering wheel)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M240i xDrive, 2023 BMW M240i, 2023 BMW 230i xDrive, 2023 BMW 230i, and 2022 BMW M240i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Airbag unit.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Before working on the airbag, disconnect the negative battery cable from the battery.
- Airbag unit may only be set down with the cushion (airbag itself) facing upwards.
- For additional information see: SAFETY REGULATIONS FOR HANDLING COMPONENTS WITH GAS GENERATORS .
NOTE:
RISK OF DAMAGE
Damage to the steering wheel.
Incorrect handling of the tool may damage the steering wheel.
Damage to the steering wheel.
Incorrect handling of the tool may damage the steering wheel.
- Make sure the position (angle and inclination) of the tool is correct.
- When unlocking, do not lever, but press in the Torx screwdriver only towards the center of the steering wheel.
NOTE:
Perform the steps on the left and right side.
- Localize the mark (1) for unlocking the airbag unit on the steering wheel by feeling.NOTE: Perform the steps on the left and right side.
- Carefully cut the mark (1) with a knife (2) to approx. 4 mm length.NOTE: TECHNICAL INFORMATION
Different variants may be installed depending on the vehicle equipment. - For vehicles with shift paddles (2) from CFRP, use a Torx socket T15 (1) for unlocking the airbag unit.NOTE: To provide a better overview: Schematic diagram with airbag unit removed.
- Insert the Torx socket T15 (1) to the top at an angle until a springy resistance can be felt.
- Press the Torx socket T15 (1) straight in arrow direction to the center of the steering wheel to unlock the wire spring (2) or the airbag unit (A).
- Press the wire spring in with the Torx socket T15 (1) in arrow direction and lift the airbag unit (2) to the unlocked side.
- Repeat the process on the left side and carefully release the airbag unit (2) from the steering wheel.
- Unlock plug connection (1) and disconnect.
- Remove the airbag unit (2).