Remove right output shaft

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M240i xDrive, 2023 BMW M240i, 2023 BMW 230i xDrive, 2023 BMW 230i, and 2022 BMW M240i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Description is for left component only. Procedure on the right side is identical.

Release the cable for the wheel speed sensor from the holders (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen the nut (1), if necessary, counter-hold the Torx socket.
Remove the anti-roll bar link (2).
Turn steering wheel to right.

Courtesy of BMW OF NORTH AMERICA, INC.
Turn swivel bearing outwards.
Set aside the anti-roll bar link (2).
Guide out the output shaft (1) from the swivel bearing.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
Secure component against falling.
Position the aluminum drift (2) on the output shaft (1).
Knock output shaft (1) with the aluminum drift (2) out of the bearing support.

Courtesy of BMW OF NORTH AMERICA, INC.
Remove the output shaft (1) in the direction of the arrow.

Courtesy of BMW OF NORTH AMERICA, INC.