Releasing the engine bridge from the crankcase
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M240i xDrive, 2023 BMW M240i, 2023 BMW 230i xDrive, 2023 BMW 230i, and 2022 BMW M240i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
- Lower the engine by turning the special tool 2 361 506 (00 6 103)
until the engine lies completely on the engine mounts and the engine mounting bracket (1) is loose on the special tool (2) 0 493 997 (11 8 350).
- Feed out the engine mounting bracket (3) on the special tool 0 493 997 (11 8 350) and set aside.
- Release the screw (1) and feed out the nut (2) and remove it.
- Remove the special tool 0 493 997 (11 8 350) and set aside.
- Tighten the screw (1) on the starter generator.TIGHTENING TORQUES SPECIFICATION
Alternator on component carrier M10x75 Tightening torque 38 Nm M10x125 Tightening torque 38 Nm M10x90 Tightening torque 38 Nm - Remove the engine bridge (1) with a support person.
- Tighten the screw (1) of the right engine mount with a commercially available tool from the top.TIGHTENING TORQUES SPECIFICATION
Alternator on component carrier M12 Tightening torque 100 Nm - Keep all the standard tools ready.
Number Description 1 Standard torque wrench 2 Swiveling extension 3 External Torx E14 - Position suitable tools (1).
- Tighten bolt (1) of the left engine mount using a standard tool (2) sideways.TIGHTENING TORQUES SPECIFICATION
Alternator on component carrier M12 Tightening torque 100 Nm
NOTE:
TECHNICAL INFORMATION
Conduct the following operation with the assistance of a second person.