Install the wiring harness
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M240i xDrive, 2023 BMW M240i, 2023 BMW 230i xDrive, 2023 BMW 230i, and 2022 BMW M240i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The following step(s) must be performed if the specified component(s) is/are installed.
- Position the (3) vibration actuator.
- Connect and lock connector for the vibration actuator (3).
- Position the (2) grounding cable.
- Tighten the screws (1).TIGHTENING TORQUES SPECIFICATION
Balance weight/vibration actuator on steering wheel Screw tightening torque 2.2 Nm - Position the balance weight (3) if necessary.
- Position the (2) grounding cable.
- Tighten down screws (1).TIGHTENING TORQUES SPECIFICATION
Balance weight/vibration actuator on steering wheel Screw tightening torque 2.2 Nm - Position and fasten the wiring harness (3) to the steering wheel.
- Connect connectors (1) and lock.
- Connect and lock the connector (2) if necessary.