If installed: Securing the engine oil cooler

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M240i xDrive, 2023 BMW M240i, 2023 BMW 230i xDrive, 2023 BMW 230i, and 2022 BMW M240i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Remove cable tie (2).
Position engine oil cooler (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Guide in and install engine oil cooler (2) on holder (3) in the arrow direction.
Ensure that lock (1) snaps in audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten down screw (1).

TIGHTENING TORQUES SPECIFICATION

Engine oil cooler on bumper bracket
M6X25	tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Replace the rivet (2).
Parts: rivet
Install and rivet the damper (3).

Tighten down screws (1).

TIGHTENING TORQUES SPECIFICATION

Lower side cover at front
Hexagon screw for thermoplastic	Tightening torque	3 Nm

Courtesy of BMW OF NORTH AMERICA, INC.