Installing the headlining side rear
WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.
- Position the headlining (2).
- Tighten the screws (1).TIGHTENING TORQUE SPECIFICATIONS
Headlining support to hood linkage Torx bolt Tightening torque 2.8 Nm - Position the headlining (2).
- Tighten down screw (1).TIGHTENING TORQUE SPECIFICATIONS
Headlining support to hood linkage Torx bolt Tightening torque 2.8 Nm - Feed in the tension cable (1) at the retaining tab (2) on the convertible top brace.
- Feed in the tension cable (1) at the retaining strap (2) and at the convertible top linkage in the area (3) in the arrow direction.
- Continue feeding in the tension cable (1) at the convertible top linkage in the area (2) in the arrow direction.
- Route the tension cable (1) through the guides (2) and (3) at the convertible top linkage.
- Continue routing the tension cable (1) around the guide (2) in arrow direction.
- Fasten the tension cable (1) on the convertible top linkage using a new Jetpress plastic rivet (3).
- Feed in the tension cables (1) through the guides at the convertible top linkage (2).
- Position the rubber grommet (2) at the tension cables (1).
- Feed in the tension cables (1) at the guide (3) on the convertible top linkage.
- Position the rubber grommet (3) at the tension cables (4).
- Fasten the tension cables (4) on the convertible top linkage using the bolt (2).
- Insert the retaining clip (1).
- Position the tension cable (2).
- Fasten blind rivet (1).