Installing the bearing bracket for the pedal mechanism

WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.

Install bearing bracket (2).
Replace the screw (1).
Parts: Screw
Position and tighten the screw (1).

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUE SPECIFICATIONS

Pedal bracket on body M8 Replace screw.	tightening torque	22 Nm

Replace nuts (1).
Parts: Nuts
Install the nuts (1) and tighten.

TIGHTENING TORQUE SPECIFICATIONS

Brake booster to pedal assembly console
Replace nuts. M8 Retighten 1x on brake booster after 10 min.	tightening torque	22 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The following step(s) must be performed if the listed component(s) is/are installed.

Connect connector (1).

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The following step(s) must be performed if the listed component(s) is/are installed.

Connect connector (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Lock brake pedal (1) in place in the arrow direction with the brake booster.

Make sure that the brake pedal is completely locked with the brake booster!

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING THE TRIM PANEL FOR THE PEDAL ASSEMBLY .