Remove the rear anti-roll bar

WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Car may slip off the vehicle hoist where components are supported.
Danger! Immobilization period-threatening injuries!

Secure the vehicle hoist against lowering and lifting.
Make sure that the vehicle does not lift off the mounting plates on the vehicle lift.

WARNING: Car may slip off the vehicle hoist if the weight is distributed unevenly.
Danger! Immobilization period-threatening injuries!

Ensure there is a specific weight compensation on the car.

WARNING: Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly.
Danger! Immobilization period-threatening injuries!

Observe safety instructions on raising the vehicle using a vehicle hoist.
For additional information see: 00... RAISE THE VEHICLE USING A VEHICLE LIFT .

Preliminary work

Refer to REMOVING THE REAR LEFT AND RIGHT WHEELS .
Refer to RELEASING CABLE FROM THE REAR AXLE SUPPORT .
Refer to REMOVING THE CONNECTING SUPPORT FROM THE TUNNEL .
Refer to REMOVING EXHAUST SYSTEM .
Refer to REMOVING TANK COVER ON LEFT AND RIGHT .
Refer to REMOVING THE LEFT AND RIGHT THRUST FIELDS AND THE TORSION STRUT .
Refer to REMOVING THE REAR HEAT SHIELD .
Refer to RELEASING THE PROP SHAFT FROM THE REAR AXLE DIFFERENTIAL .
Refer to LOOSENING THE ANTI-ROLL BAR LINK ON THE LEFT AND RIGHT FROM THE ANTI-ROLL BAR .
Refer to TENSIONING THE COIL SPRING LEFT AND RIGHT .
Refer to PREPARING THE SPECIAL TOOL .
Refer to LOWERING REAR AXLE SUPPORT .

NOTE: TECHNICAL INFORMATION
Incorrect assembly is possible. Ensure correct installation position.

NOTE: To provide a better overview: Schematic diagram with partially hidden components.

Loosen screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Feed out and remove the rear anti-roll bar (1) sideways.

Courtesy of BMW OF NORTH AMERICA, INC.