Installing the right thrust field
WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Position the left thrust field (4).
- Replace screws (2) and (3).
Parts: Screws
- Screw in screws (2) and (3) a few turns.
- Tighten screws (arrows).
TIGHTENING TORQUE SPECIFICATIONS
| Thrust field to body | ||
| M8 | Tightening torque | 28 Nm |
- Tighten the screws (2).
TIGHTENING TORQUE SPECIFICATIONS
| Thrust field to outer body | ||
| M10 Replace screw. | Tightening torque Angle of rotation |
56 Nm 90° |
- Tighten down screw (3).
TIGHTENING TORQUE SPECIFICATIONS
| Thrust field to door sill | ||
| M12 Replace screw. | Tightening torque Angle of rotation |
100 Nm 90° |
- Replace nut (1).
Parts: Nut
- Tighten nut (1).
TIGHTENING TORQUE SPECIFICATIONS
| Thrust field to rear axle support | ||
| M10 Replace nut. | Tightening torque Angle of rotation |
56 Nm 90° |
- Position ground strap (2) on the right thrust field (3).
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Ground strap to thrust field | ||
| M6 | Tightening Torque | 6.4 Nm |
Follow-up work
- Refer to INSTALLING THE CONNECTING SUPPORTS ON THE TUNNEL .
- Refer to INSTALLING RIGHT TANK COVER .