Installing the rear emblem
WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
TECHNICAL INFORMATION
Notes on component bonding using adhesive tape form the basis for these repair instructions and must be observed without fail.
For additional information see: NOTES ON COMPONENT BONDING WITH ADHESIVE TAPE (M4 2021-2023) .
Notes on component bonding using adhesive tape form the basis for these repair instructions and must be observed without fail.
For additional information see: NOTES ON COMPONENT BONDING WITH ADHESIVE TAPE (M4 2021-2023) .
- Replace the emblem.
Parts: Emblem
- If applicable, remove adhesive residue from the tailgate.
- Clean bonding surface (1).CONSUMABLE SPECIFICATION
Cleaning agent R2 500 ml 83190417324 - Adhere to the air drying time of 2 min.
- Check guide pins (2).
The guide pins (2) must not be damaged or missing.
- If installed: Installing the rearview camera (RFK)
- Check the sealing ring (1) for fit accuracy.
- Insert the rearview camera (RFK) (3) in the socket of emblem (4).
- Close the lid (2) and clip in with the detents (1).
- Attach the emblem (2) with the rearview camera (RFK).
- Connect connectors (1) and lock.
- Detach the liner from adhesive tape of the emblem (1).
- Position the emblem (1) correctly with guide pins (2) and press on firmly.