Installing the servomotor for the eccentric shaft (cylinder head removed)
WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.
- Replace seal (1)
.
Parts: Gasket
- Press the seal (1)
up to the limit position on the housing.
- Grease the gearing (1) of the servomotor (2) for the eccentric shaft in marked area.
CONSUMABLE DESCRIPTION
| Lubricating grease Longtime PD-1 | 400 g, Cartridge | 83192160340 |
- Clean sealing surface (1)
.
- Feed in and install the servomotor (1) for the eccentric shaft up to the stop.
- Turn the servomotor (1) for the eccentric shaft with a commercially available Allen wrench (2) with 4 mm in arrow direction until the servomotor (1) lies on the cylinder head for the cylinder head.
- Tighten down screws (3) .
TIGHTENING TORQUE SPECIFICATIONS
| Electrical servomotor to cylinder head | ||
|---|---|---|
| M6 | Tightening torque | 8 Nm |