Releasing the wishbone, tension strut and tie rod end from the swivel bearing

WARNING: This page is about a different car, the 2025 BMW M4, 2024 BMW M4, 2023 BMW M4, 2022 BMW M4, and 2021 BMW M4. However, it is still accessible from the selected car via links, so may be relevant.

Release nut (1). If necessary, counter support at the Torx socket.
Release the tension strut (2) from the swivel bearing (3).

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Only perform the operation on the left side.
Release the attachment rod (1) from the ride height sensor (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Release nut (1). If necessary, counter support at the Torx socket.
Release the wishbone (2) from the swivel bearing (3).

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
Otherwise, the rubber grommet can be damaged. The components must not be in contact.
Make sure that the rubber grommet (3) on the bottom wishbone (1) is not damaged by the swivel bearing (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Release nut (1). If necessary, counter support at the Torx socket.
Release the tie rod end (2) from the swivel bearing.

Courtesy of BMW OF NORTH AMERICA, INC.