Install the front upper seat belt (REMA)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
TECHNICAL INFORMATION
Clean all threaded belt connections with micro-encapsulated outer and internal threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength.
The screw connection must be completed within 10 minutes as hardening begins after this period.
Clean all threaded belt connections with micro-encapsulated outer and internal threads.
Shavings or other debris must not remain in the components.
If a microencapsulated screw is reused, it must be coated with the following screw locking agent: Loctite 243, medium strength.
The screw connection must be completed within 10 minutes as hardening begins after this period.
- Position the inertia reel (1) correctly.NOTE: TECHNICAL INFORMATION
SA5AL Active Protection:
REMA = Reversible electromotive reel. - Replace the screw (1).
Parts: Screws
Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATIONFront seat belt retractor to body Screw
Replace screw.Tightening torque 42 Nm - Tighten down screw (3).
- Connect the plug connections (1) and lock.
- Install the idler pulley (4).
- Tighten down screw (3).TIGHTENING TORQUES SPECIFICATION
Seat belt guide loop on body M10 screw Tightening torque 42 Nm - Attach slide bar (2).
- Tighten down screws (1).