Install the centrifugal disc on the transfer box (VTG) (ATC 13-1)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
- Replace protective cap (1) .
Parts: protective cap
- Carefully tap the protective cap (1) with the special tool onto the transfer box 0 494 641 (27 1 380) .
- Replace centrifugal blade (1) .
Parts: Centrifugal disc
- Carefully tap the centrifugal disc (1) with a plastic hammer onto the transfer box (2) .
Follow-up work
- Refer to INSTALLING THE TRANSFER BOX (ATC 13-1) .
- Refer to CHECKING/TOPPING UP THE TRANSFER BOX OIL (ACTIVE TORQUE CONTROL 13-1) .
- Refer to FASTENING THE PROP SHAFT (PARTIALLY REMOVED) .
- Refer to INSTALLING TRANSMISSION CROSS MEMBER .
- Refer to INSTALLING THE HEAT SHIELDS .
- Refer to INSTALLING EXHAUST SYSTEM .
- Refer to INSTALLING THE REAR TUNNEL CONNECTING SUPPORT .
- Refer to INSTALLING THE REINFORCEMENT STRUT .
- Refer to INSTALLING UNDERSHIELD ON THE FUEL TANK ON THE RIGHT .
- Refer to INSTALLING THE UNDERSHIELD ON THE LEFT FUEL TANK .
- Refer to INSTALLING THE REAR DIFFUSER .
- Refer to CONNECTING BATTERY GROUND LEAD