11 22 513 Replacing roller bearing for dual-mass flywheel (M5 2018-2022)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 21 2 051
- 21 2 052
NOTE:
Flywheel removed!
Using hydraulic press (1) and special tool 21 2 051 , press roller bearing out of dual-mass flywheel downwards on engine side.
IMPORTANT:
Risk of damage:
Roller bearing must not be driven out.
Roller bearing must not be driven out.
Push roller bearing (2) onto special tool 21 2 052 .
Using hydraulic press (1), press roller bearing into dual-mass flywheel to stop on clutch side.
IMPORTANT:
Risk of damage:
Observe press-in instruction:
Min. 2000 N 1 mm before end of pressing in.
Max. 15.000 N during entire press-in procedure.
Observe press-in instruction:
- Roller bearing must not be driven in.
- Roller bearing mounting force/travel monitored:
Min. 2000 N 1 mm before end of pressing in.
Max. 15.000 N during entire press-in procedure.