Installing the safety pressure switch N63/S63
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
- Correctly position and tighten the safety pressure switch (2).
TIGHTENING TORQUES SPECIFICATION
| Safety pressure switch | ||
|---|---|---|
| Tightening torque | 10 Nm | |
- In case of restricted accessibility:
Tighten the safety pressure switch (2) with the special tool 0 490 295 (00 3 204) .
TIGHTENING TORQUES SPECIFICATION
| Safety pressure switch | |
|---|---|
| Tightening torque | 10 Nm |
- Insert and connect the connector (1).
Follow-up work
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING FRONT CROSS CONNECTION .
- Refer to TIGHTENING THE LEFT FRONT-END STRUT .
- Refer to TIGHTENING THE FRONT-END STRUT ON THE RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
- Refer to CONNECTING BATTERY GROUND LEAD .
- Refer to EVACUATING AND CHARGING CONDITIONING .