Installing the positive battery cable power distribution at the rear
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
- Feed in power distribution of positive battery cable (3).
- Tighten down screw (2).
TIGHTENING TORQUES SPECIFICATION
| Power distribution box, positive battery terminal | ||
|---|---|---|
| Screw TS6x20 | Tightening torque | 1.2 Nm |
- Connect all connectors (1).
- Tighten the positive battery cable (3) using the nut (2).
TIGHTENING TORQUES SPECIFICATION
| Positive battery cable | ||
|---|---|---|
| Positive pole screw | tightening torque | 15 Nm |
- Close the cover (1).
Follow-up work
- Refer to INSTALLING THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE RIGHT .
- Refer to INSTALLING THE REAR SEAT AND THE REAR SEAT BACKREST (NOT FOR THE SA465 PASS-THROUGH SYSTEM) .
- Refer to INSTALLING RIGHT BACKREST SIDE SECTION .
- Refer to INSTALLING LOADING EDGE TRIM .
- Refer to CONNECTING BATTERY GROUND LEAD .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .