Removing the right spindle drive

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Shutting hood or trunk lid.
Injury hazard!

Support hood/trunk lid in fully open position with the aid of a suitable device.

NOTE: RISK OF DAMAGE
Damage to the spindle drive.
If the trunk lid is not opened completely, the spindle drive may be damaged.

Remove and install the spindle drive only when the Trunk lid is open to the maximum extent.

Preliminary work

Refer to REMOVING THE LUGGAGE COMPARTMENT FLOOR COVERING .
Refer to REMOVING THE LOADING EDGE TRIM .
Refer to PARTIALLY REMOVING THE RIGHT LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL .

Unlock plug connection (1) and disconnect.
Observe disassembly sequence:
1. Push the clamp in the direction of the groove with the screwdriver.
2. Lift off the ball socket from the ball hub.
3. Push back the clamp.
4. Detach the ball socket from the ball hub.
Remove spindle drive (2).

Courtesy of BMW OF NORTH AMERICA, INC.