Install the cup holder

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

Connect associated connector.
Clip in the cup holder (1) from the top.
Tighten down screws (2).
TIGHTENING TORQUE SPECIFICATIONS

Cupholder

1.8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.
Insert the insert (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to FASTENING THE CENTER CONSOLE TRIM ON THE CENTER CONSOLE .
Refer to INSTALLING THE CENTER ARMREST .
Refer to INSTALLING THE CENTER ARMREST STORAGE COMPARTMENT .