Removing the wiring harness section of DME for the integrated power supply module
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Hot surfaces
.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
NOTE:
TECHNICAL INFORMATION
Driving without the strut brace/front-end strut or tension strut is not permitted.
Driving without the strut brace/front-end strut or tension strut is not permitted.
Preliminary work
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING THE COVER PANEL OF THE MASTER DME CONTROL UNIT .
- Refer to REMOVING THE COVER PANEL OF THE SLAVE DME CONTROL DEVICE .
- Refer to REMOVING HOLDER OF DME CONTROL UNIT FOR CYLINDERS 5 TO 8 .
- Refer to REMOVING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
- Refer to REMOVING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
- Refer to RELEASING LEFT FRONT-END STRUT .
- Refer to RELEASING THE RIGHT FRONT-END STRUT .
- Refer to REMOVING LEFT INTAKE SILENCER HOUSING .
- Refer to REMOVING THE CLEAN AIR PIPE OF CYLINDER BANK 1 .
- Refer to REMOVING RIGHT INTAKE SILENCER HOUSING .
- Refer to REMOVING THE CLEAN AIR PIPE OF CYLINDER BANK 2 .
Wiring harness section of DME for the integrated power supply module
- Unlock and disconnect the wiring harness section of DME for the integrated power supply module at the snap-in lug (1).
- Loosen screw (2).
- Place cable lugs (1) to one side.
- Unlock and disconnect the plug connection of the alternator (1).
- Remove the wiring harness from the bracket in the area (2).
- Unlock and disconnect the wiring harness section of DME for the integrated power supply module at the snap-in lug (1).
- Loosen nut (2).
- Place cable lugs (1) to one side.
- Unlock and disconnect the connector (1) on the integrated power supply module.
- Unlock and disconnect the connector on the DME master control unit at the area (2).
- Unlock the wiring harness mounting (3) and move it up to one side.
- Feed out and remove the wiring harness section of DME for the power distribution module.