Subsequent removal and installation of the servomotor due to oil leak: Checking the oil level in the rear axle differential
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
RISK OF DAMAGE
Damage to rear axle differential.
Failure to comply with the oil specifications can result in serious damage to the rear axle differential.
Damage to rear axle differential.
Failure to comply with the oil specifications can result in serious damage to the rear axle differential.
- After completion of repair work, check the transmission oil level in the rear axle differential.
- Use only the approved final drive transmission oil.
- Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations. It is not possible to check the oil level in the rear axle differential. It is imperative that the oil is drained from the rear axle differential and refilled with a previously measured oil quantity.
Draining the rear differential fluid
NOTE:
TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
- Place oil collecting apparatus underneath.
- Release the oil filler plug (1) .
- Drain and dispose of the rear differential fluid.
- Replace (1)
screw plug.
Parts: Plug
- Tighten the oil filler plug (1) .
TIGHTENING TORQUES SPECIFICATION
| Screw plug on final drive cover | ||
| M22 Replace screw plug with O-ring. |
Tightening torque | 45 Nm |
Topping up the rear differential fluid
NOTE:
TECHNICAL INFORMATION
Rear differential fluid must be shaken (mixed) prior to use so that the additive distributes evenly in the oil.
Filling capacity for the rear axle differential must be observed!
Filling up to the lower edge of the oil filler opening would overfill the rear axle differential.
Rear differential fluid must be shaken (mixed) prior to use so that the additive distributes evenly in the oil.
Filling capacity for the rear axle differential must be observed!
Filling up to the lower edge of the oil filler opening would overfill the rear axle differential.
NOTE:
TECHNICAL INFORMATION
It is imperative to ensure that there is no air in the hose when topping up a defined (measured) oil quantity.
It is imperative to ensure that there is no air in the hose when topping up a defined (measured) oil quantity.
- Use special tool 2 460 340 for topping up.
- To top up a defined (measured) oil quantity, first fill hose (1)
with oil. To do this, connect adapter (2)
.
Supplement the rear differential fluid change/oil level with oil gun
NOTE: TECHNICAL INFORMATION
The training video schematically shows the method for changing the oil in the rear axle differential using the oil sprayer special tool.
The training video is not a replacement for the repair instructions.
The training video is not subject to the update service.
We can assume no liability for printing errors or inaccuracies in this service information and reserve the right to introduce technical modifications at any time.Refer to:
multimedia:A supplement to the article is available.- Follow repair instructions!
- Release the oil filler plug (1) .
- Shake (mix) the rear differential fluid before use.
- Measure the required filling capacity and top up the rear differential fluid.
TECHNICAL DATA SPECIFICATIONRear differential fluid Filling capacity (shake/mix rear axle differential oil before use) 1 l - Replace (1)
screw plug.
Parts: Plug
- Tighten the oil filler plug (1) .
TIGHTENING TORQUES SPECIFICATION
| Screw plug on final drive cover | ||
| M22 Replace screw plug with O-ring. |
Tightening torque | 45 Nm |