Installing the anti-roll bar
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
- Guide the anti-roll bar (3) in and position it.
NOTE:
Make sure that the retainers for the anti-roll bar and the upper sections of the holder are positioned correctly.
- Replace screws (1) and (2).
Parts: Screws
- Tighten down screws (1) and (2).
Screws of different lengths. Note installation position!
Screws (1) = M12x89
Screws (2) = M12x50
TIGHTENING TORQUE SPECIFICATIONS
| Anti-roll bar to front axle support | ||
| M12 Replace screws. | Joining torque Angle of rotation |
100 Nm 45° |