Install the module bracket on the rear door
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
- Check seal (1) of the module bracket (2) for damage.
If the seal (1) is damaged, the module carrier (2) must be replaced.
- Feed in module bracket completely with the power window and close the snap fasteners (2).
- Attach wiring harness (1) and connect the plug connections.
- Tighten the screws (1).TIGHTENING TORQUE SPECIFICATIONS
Module bracket to door screw Tightening torque 8 Nm - Shift the power window upwards until the side window glass correctly engages in the holder.
- Remove adhesive tape.
Follow-up work
- Refer to INSTALLING REAR DOOR TRIM PANEL .
- Refer to ATTACHING THE COVER TO THE DOOR HANDLE .
- Refer to INSTALLING WINDOW CHANNEL STRIP ON THE REAR DOOR .