Flush and bleed the front axle brake circuit (brake high)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW M5, 2022 BMW M5, 2021 BMW M5, 2020 BMW M5, and 2019 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Description is for right component only. The procedure on the left side is identical.
- Two different fixed brake calipers are installed!
- In both variants, the outside (1) must be vented first.
Then vent on the inside (2).
- Start flushing at the right front.
- Connect the vent hose with the collecting vessel to the bleed valve (1) on the front right brake caliper.
- Open the bleed valve (1) and purge it until clear, bubble-free brake fluid emerges.
- Close bleed valve (1).
TIGHTENING TORQUES SPECIFICATION
| Front bleed valve from brake caliper manufacturer Brembo | ||
| Bleed valve | Tightening torque | 18 Nm |
TIGHTENING TORQUES SPECIFICATION
| Fixed caliper front bleed valve from bake caliper manufacturer Continental | ||
| Bleed valve | Tightening torque | 15 Nm |
- Connect the vent hose with the collecting vessel to the bleed valve (1) on front right brake caliper.
- Open bleed valve (1) and purge it until clear, bubble-free brake fluid emerges.
- Close bleed valve (1).
TIGHTENING TORQUES SPECIFICATION
| Front bleed valve from brake caliper manufacturer Brembo | ||
| Bleed valve | Tightening torque | 18 Nm |
TIGHTENING TORQUES SPECIFICATION
| Fixed caliper front bleed valve from brake caliper manufacturer Continental | ||
| Bleed valve | Tightening torque | 15 Nm |
- Carry out the same procedure on the front left wheel brake.