Installing the backrest side section with the side airbag
WARNING:
Airbag unit
.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Before performing any work on the airbag, always disconnect the battery ground lead from the battery.
- Airbag unit may only be set down with the cushion (airbag itself) facing upwards.
- For additional information see: SAFETY REGULATIONS FOR HANDLING COMPONENTS WITH GAS GENERATORS .
WARNING:
Pyrotechnic components
.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.
- Replace any damaged part or ones that have been dropped.
- For additional information see: SAFETY REGULATIONS FOR HANDLING COMPONENTS WITH GAS GENERATORS .
NOTE:
To provide a better overview: Schematic diagram with partially hidden components.
- Check to ensure that the cable (arrows) fit correctly.
- Insert backrest side section (1) into the lower guide and position it correctly.
- Clip in the backrest side section (1) on the mounting element (2).
- Tighten the screws (1).
TIGHTENING TORQUES SPECIFICATION
| Backrest side section to body | ||
| M6x30 | Tightening torque | 8 Nm |
- Connect connectors (2) and lock.
The connector (2) must engage audibly.
Follow-up work
- Refer to INSTALLING THE REAR SEAT .
- Refer to ACTIVATING ELECTRICAL SYSTEM .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .