Installing the guide for the rear bumper cover at the center
- Position guide (3) for the rear bumper cover in the center.
- Tighten nuts (2)
.TIGHTENING TORQUE SPECIFICATION
Bumper guide to body Hexagon nut Tightening torque 4.6 Nm - Clip wiring harness (1) into all the holders and, if necessary, connect the existing plug connections.
Follow-up work
- Refer to INSTALLING THE REAR BUMPER COVER .
- Refer to INSTALLING TAIL LIGHT ON LEFT AND RIGHT SIDE PANEL .
- Refer to INSTALLING THE TRIM IN THE WATER CHANNEL ON THE LEFT AND RIGHT .
- Refer to INSTALLING THE LEFT AND RIGHT LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL (PARTIALLY REMOVED) .
- Refer to INSTALLING LOADING EDGE TRIM .
- Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .