Installing the module bracket on the front door

Check 

• Check seal (1) on the module bracket on the front door for damage.

  Courtesy of BMW OF NORTH AMERICA, INC.

  Result 

  » Seal (1) is damaged.

  Measure

• Replace the module bracket on the front door.
• Position the module bracket (3) on the front door.

  While doing this, guide Bowden cable (2) for the inner door opener into module bracket (3) on the front door.

• Lock the bayonet closures (1) by rotating them.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten the screws (1).
  TIGHTENING TORQUE SPECIFICATION
  
  

  Module bracket to front door
  Oval-head screw M6	tightening torque	9 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Install rubber grommet (3) of the Bowden cable for the inner door opener.
• Clip in the wiring harness (2) to the module bracket on the front door.
• Connect connectors (1) and lock.

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE FRONT DOOR TRIM PANEL .
• Refer to ACTIVATING ELECTRICAL SYSTEM .
• Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .