Installing the control unit for the optional equipment system (SAS)

Position the control unit for the optional equipment system (SAS) (1) .
Replace the plastic nuts (3) .
Parts: Plastic nuts
Fix the plastic nuts (3) and tighten them.

TIGHTENING TORQUE SPECIFICATION

Control unit for the optional equipment system (SAS) to the holder
Replace plastic nut.	Tightening torque	4 Nm

Connect the plug connection (2) .

G14641270

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING THE TRIM PANEL FOR THE PEDAL ASSEMBLY .