Installing the electric coolant pump for the charge air cooler and the air conditioning condenser

• Position the electric coolant pump (2)  .
• Connect connectors (1)  and lock.

  The connector (1)  must engage audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Insert and install the retainer (2)  .
• Make sure the retainer (2)  is positioned correctly  .
  NOTE: RISK OF DAMAGE 
  Improper screw length can cause component damage  .
  The use of screws of improper length can lead to component damage  .

  • Note the correct screw length.
  • Install screws that correspond to the original length.
• Tighten the screws (1)  .
  TIGHTENING TORQUE SPECIFICATION
  
  

  Electric coolant pump on component carrier
  M6 Replace screws.	tightening torque	8 Nm

• Connect and lock coolant line (2)  and (3)  .
• Make sure that you can hear coolant lines (2)  and (3)  engage.
• Secure the clamp (1)  .
• Secure the coolant line (3)  to the holder (4)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE THROTTLE BODY .
• Refer to INSTALLING CHARGE AIR LINE .
• Refer to INSTALLING THE CLEAN AIR PIPE WITH THE RESONATOR .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to FILLING THE LOW-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
• Refer to CONNECTING NEGATIVE BATTERY CABLE OF THE SYSTEM BATTERY .
• Refer to VENTING THE LOW-TEMPERATURE COOLING SYSTEM .
• Refer to INSTALLING THE STIFFENING PLATE .
• Refer to INSTALLING FRONT UNDERBODY PROTECTION .