Install the DSC control unit
NOTE:
TECHNICAL INFORMATION
Maintain conditions of absolute cleanliness.
Maintain conditions of absolute cleanliness.
- Carefully mount the DSC control unit (1) on the hydraulic unit.
- Replace the screws (2)
.
Parts: Screws
- Tighten screws (2) crosswise gradually.
TIGHTENING TORQUE SPECIFICATION
| DSC control unit on hydraulic unit | ||
| Screw Replace screws. Screw in screws and evenly tighten crosswise. |
1. Tightening torque | 1.5 Nm |
| 2. Tightening torque | 2.5 Nm | |
| Position the 3rd tightening torque | 3.5 Nm | |
- Install holder (2) .
- Replace screws (1)
.
Parts: Screws
- Insert screws (1) and tighten.
TIGHTENING TORQUE SPECIFICATION
| Hydraulic control unit to holder | ||
| M6 Replace screws. |
Tightening torque | 8 Nm |
Follow-up work
- Refer to INSTALLING THE HYDRAULIC UNIT .
- Refer to INSTALLING COOLANT EXPANSION TANK .
- Refer to REMOVING THE BRAKE PEDAL TENSIONER .
- Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
- Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to FLUSH AND VENT THE REAR AXLE BRAKE CIRCUIT .
- Refer to FLUSHING AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT .
- Refer to FLUSH AND BLEED THE FRONT AXLE BRAKE CIRCUIT (BRAKE HIGH) .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to DSC UNIT START-UP/DRIVING DYNAMICS SENSOR ADJUSTMENT/CONTROL UNIT PROGRAMMING .