Mount rear brake guard plate
- Install brake guard plate (2) .
- Replace screws (1)
.
Parts: Screws
- Insert screws (1)
and tighten.TIGHTENING TORQUE SPECIFICATIONS
Brake protection plate on the rear wheel carrier M6x12
Replace screw.tightening torque 8 Nm
Follow-up work
- Refer to INSTALL REAR BRAKE DISCS .
- Refer to GREASE BRAKE PADS, BRAKE ANCHOR PLATE AND BRAKE CALIPER WITH BRAKE PAD PASTE .
- Refer to INSTALLING REAR BRAKE PADS .
- Refer to PLACING THE BRAKE PADS ON THE BRAKE DISK/PUTTING THEM INTO OPERATION .
- Refer to INSTALLING THE REAR BRAKE PAD WEAR SENSOR .
- Refer to INSTALLING THE REAR LEFT AND RIGHT WHEEL .
- Refer to START-UP OR BEDDING IN BREAK-IN OF NEW BRAKE PADS AND BLADES (REAR BRAKE) .