Installing left output shaft

• Fold open the assembly protection ring (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Guide the output shaft (1) in the direction of the arrow into the front axle transmission, but do not  allow it to engage.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Pull on the lug of the installation protection ring (2) until one of the two predetermined breaking points breaks.
• Pull out and dispose of the installation protection ring (2).
• Push the output shaft (1) into the front axle transmission as far as it will go.

  The output shaft (1) must engage noticeably and audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to POSITION THE OUTPUT SHAFT ON THE SWIVEL BEARING .
• Refer to PLACING THE OUTPUT SHAFT ASIDE .
• Refer to SECURING THE WISHBONE AT THE SWIVEL BEARING .
• Refer to DRAINING AND TOP UP THE FRONT AXLE TRANSMISSION OIL .
• Refer to FASTENING THE OUTPUT SHAFT ON THE WHEEL BEARING .
• Refer to SECURING THE TIE ROD ON THE SWIVEL BEARING .
• Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
• Refer to INSTALLING THE COVER OF THE STEERING ASSEMBLY .
• Refer to ATTACHING THE FRONT LEFT WHEEL .