Installing the control unit for the EMF
- Carefully attach the DSC control unit (5) to the hydraulic unit.
- Replace screws (1)
to (4)
.
Parts: Screws
- Tighten the screws (1)
to (4)
step by step in this sequence.TIGHTENING TORQUES SPECIFICATION
DSC control unit on hydraulic unit Screw
Replace screws.
Screw in screws and evenly tighten crosswise.1. tightening torque 1.5 Nm 2. tightening torque 2.5 Nm Position the 3rd tightening torque 3.5 Nm - Install holder (2) .
- Insert screws (1) and tighten.
TIGHTENING TORQUES SPECIFICATION
| Hydraulic control unit to holder | ||
|---|---|---|
| M6 Replace screws. |
Tightening torque | 8 Nm |
Follow-up work
- Refer to INSTALLING THE HYDRAULIC UNIT .
- Refer to INSTALLING THE LEFT FRONT-END STRUT .
- Refer to INSTALLING COOLANT EXPANSION TANK .
- Refer to INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER .
- Refer to PARTIALLY INSTALLING THE FRONT WHEEL ARCH TRIM .
- Refer to ATTACHING THE FRONT LEFT WHEEL .
- Refer to REMOVING THE BRAKE PEDAL TENSIONER .
- Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
- Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to FLUSHING AND VENTING THE REAR AXLE BRAKE CIRCUIT .
- Refer to FLUSHING AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT (BRAKE HIGH) .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to DSC UNIT START-UP/DRIVING DYNAMICS SENSOR ADJUSTMENT .