Install bumper cover, front

• Position bumper cover (1) and engage in area of air flap control at top in mountings (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: Perform the steps on the left and right side.
• Connect connector (4).
• Clip bumper cover (2) into detents (3).
• Tighten down screws (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Front bumper cover on side wall
  Hexagon screw	Tightening torque	3 Nm

• Connect connector (1) in the right wheel well.
• Hook connector (1) into holder (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Underbody protection
  Hexagon screw	Tightening torque	3 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Bumper cover, top
  M6x20	Tightening torque	4.6 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to PARTIALLY INSTALLING THE FRONT SECTIONS OF BOTH WHEEL ARCH COVERS AT THE FRONT .
• Refer to PARTIALLY INSTALLING BOTH FRONT WHEEL ARCH TRIMS .
• Refer to INSTALLING FRONT ORNAMENTAL GRILLE .