Install tension strut on shock tower

• Install the tension strut on the shock tower (3)  .
• Replace the screw (1)  .

  Parts:  Screw

• Tighten the screws (1)  .
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Tension strut on bulkhead
  M10x25 screw Replace screw.	Joining torque	56 Nm
  	Angle of rotation	90°

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace the screw (2)  .

  Parts:  Screw

• Tighten the screws (2)  .
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Tension strut to shock tower
  Torx bolt Replace screw.	Joining torque	56 Nm
  	Angle of rotation	90°

Follow-up work 

• Refer to INSTALLING THE SEAL FOR THE HOOD GASKET LEFT AND RIGHT .
• Refer to INSTALLING WINDSHIELD PANEL COVER .
• Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
• Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
• Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .