Install coolant line between coolant pump and heat exchanger

• Replace O-ring (1)  in the coolant pump.

  Parts:  O-ring

  Courtesy of BMW OF NORTH AMERICA, INC.

• Guide in coolant line and lock.
• Connect coolant line to retaining clip (2)  and lock.

Courtesy of BMW OF NORTH AMERICA, INC.

Installing the left throttle body 

Replacing the seal on the left intake system 

• Replace the seal (1)  .

  Parts:  Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Prepare the throttle body 

• Replace the seal (1)  .

  Parts:  Seal

Courtesy of BMW OF NORTH AMERICA, INC.

• Position throttle body.
• Check the plug connection (1)  for coolant residue. If necessary, clean with compressed air.
• Connect plug connection (1)  and lock.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace screws (1)  .

  Parts:  Screws

• Tighten screws (1)  of the throttle body (2)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Fix wiring harness mounting (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten the heater return 

• Position the heater return (2)  in the coolant pump.
• Tighten down screw (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE LEFT-HAND CHARGE AIR COOLER .
• Refer to CLOSING THE COOLANT PUMPS .
• Refer to FILLING THE LOW-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
• Refer to VENTING THE LOW-TEMPERATURE COOLING SYSTEM .
• Refer to INSTALLING THE STIFFENING PLATE .
• Refer to REMOVING UNDERBODY PROTECTION AT SIDE RIGHT AND LEFT .
• Refer to INSTALLING THE WHEEL ARCH COVER ON THE FRONT LEFT AND BOTTOM RIGHT .
• Refer to INSTALLING FAN COWL WITH ELECTRIC MOTOR .
• Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
• Refer to INSTALLING UPPER CROSS CONNECTION .
• Refer to INSTALLING RIGHT INTAKE SILENCER HOUSING .
• Refer to TIGHTENING THE FRONT-END STRUT ON THE RIGHT .
• Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
• Refer to TIGHTENING THE LEFT FRONT-END STRUT .
• Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
• Refer to INSTALLING THE FRONT HOOD SEAL .
• Refer to INSTALLING THE COVER PANEL OF THE MASTER DME CONTROL UNIT .
• Refer to INSTALLING THE COVER PANEL OF THE SLAVE DME CONTROL UNIT .