Installing the center of the ventilation grille with the integrated air conditioning control panel
- Place ventilation grille (2) on center stack module (3) with the integrated air conditioning control panel and position it correctly.
- Engage detents (1)
on ventilation grille (2)
.
- Engage the detents (1) .
- Tighten screws (arrows).
TIGHTENING TORQUE SPECIFICATION
| Fresh air grille to center stack module | ||
|---|---|---|
| Screw | tightening torque | 2.4 Nm |
Follow-up work
- Refer to INSTALLING THE CENTER STACK MODULE .
- Refer to INSTALLING THE WIRELESS CHARGING STORAGE .
- Refer to INSTALLING THE CUP HOLDER .
- Refer to INSTALLING THE CENTRAL INFORMATION DISPLAY (CID) .
- Refer to INSTALLING THE SPEAKER TRIM AT THE DASHBOARD .
- Refer to INSTALLING CENTER ARMREST .
- Refer to INSTALLING THE CENTER ARMREST STORAGE COMPARTMENT .
- Refer to INSTALLING THE REAR CENTER CONSOLE TRIM .
- Refer to ACTIVATING VEHICLE ELECTRICAL SYSTEM .
- Refer to ENCODING/PROGRAMING CONTROL UNIT(S) .