Installing the frame on the left and right side of the bumper cover

NOTE: Procedure shows left component only. Procedure on the right side is identical.

• Detach the bumper guide (1) with the detents (2) and remove them towards the bottom.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Release wiring harness from the holders (1).
• Release wiring harness with the holders (2).
• Unlock the detents (3) and remove the ultrasonic sensor (4) to the top.

  Ultrasonic sensor remains plugged in on the wiring harness.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen screws (1).
• Release the expanding rivet (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Detach the wiring harness from the holder on the frame (1) of the bumper cover.
• Release and remove the frame (1) at the detents (arrows).

Courtesy of BMW OF NORTH AMERICA, INC.